Changes to Step #3
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Trapezoidal nuts adjustment | |
| + | [* 1] Turn off the printer. |
| [* 2] If you have applied tension to the belt, unscrew the belt tensioner on ''x_end_idler'' until the belt is relaxed. | |
| [* 7] Loosen the screws which secure the trapezoidal nuts. This is to ensure that the Trapezoidal nuts 'self-centre' on the lead screws. | |
| [* 4] Make sure the trapezoidal nuts are moving freely. | |
| [* 5] Tighten the 4 screws alternately (on both sides). Don't apply any lateral force on the trapezoidal nuts. |