Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Belt tension |
|---|---|
| + | [* 1] Move the X axis to the middle of the Z axis and shutdown the printer. |
| + | [* 6] Tighten the belt until the belt is straight and doesn't sag. Don't tighten too much, you should still be able to pinch the belt with very little force force. |
| + | [* 5] Loosen the two pulley set screws a little. |
| + | [* 4] Adjust position of the pulley to have the belt centred. You can move the extruder by hand, to the left and right, to verify that the belt is centred. |
| + | [* 5] Tighten the set screws alternately. |
| + | [* 7] Verify that the belt is not touching the ''x_end_motor'' and that the drive pulley is not touching the X motor. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added