Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Pulley position | |
| [* 5] Loosen the two pulley set screws a little. | |
| [* 4] Align the pulley with the belt hole of the ''x_end_motor''. | |
| [* 5] Tighten the set screws alternately. | |
| - | [* 7] Verify that the belt is not touching the ''x_end_motor'' and that the drive pulley is not touching the X motor. |