Changes to Step #4

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Pulley position
-[* 5] Loosen the two pulley set screws a little.
+[* 5] Loosen both pulley set screws a little.
[* 4] Align the pulley with the belt hole of the ''x_end_motor''.
[* 5] Tighten the set screws alternately.
[* 7] Verify that the belt is not touching the ''x_end_motor''.
[* 8] Verify that the drive pulley is not touching the X motor.