Changes to Step #5
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] X smooth rods tension |
|---|---|
| + | [* 5] Grip the X motor shaft with pliers to prevent it moving (grab the flat side of the shaft). Tension the belt, by tightening the screws in the ''x_end_idler''. Do this while trying to move the extruder to the left or right. The belt should stay straight and should not bow up and skip over the drive pulley teeth. |
| + | [* 6] Thread two M3x10 screws in the ''x_end_idler''. Don't tighten them fully yet, it will be done on the next step. |
Image 1
No previous image
Added
Image 2
No previous image
Added