Changes to Step #5

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Belt pre-tension
[* 7] Grip the X motor shaft with pliers to prevent it moving (grab the flat side of the shaft).
[* 5] Tension the belt, by tightening the screws in the ''x_end_idler''. Do this while trying to move the extruder to the left or right. The belt should stay straight and should not bow up and skip over the drive pulley teeth.
-[* 10] No need to be very precise with the belt tension here as the final tension will be improved in a further step.
+[* 10] No need to be very precise with the belt tension here as the final tension will be improved later.