Changes to Step #6
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] X smooth rods tension |
|---|---|
| + | [* 6] Adjust both M3x10 screws to have the ''x_end_idler'' parallel to the frame. |
| + | [* 2] Second image shows when the X axis is too short. In this case you need to tighten the two M3x10 screws. |
| + | [* 2] Third image shows when X axis is too long. In this case you need to unscrew the two M3x10 screws. |
| + | [* 9] It might happen that with excess tension on the M3x10 screws, the Z smooth rods will start to be off center on the Z tops. In this case release tension even if the ''x_end_idler'' is not totally parallel to the frame. |
| + | [* 10] Check the next step if you have difficulty to see if the ''x_end_idler'' is parallel to the frame. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added