Changes to this Step
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] X smooth rods tension |
|---|---|
| + | [* 1] If you have difficulty to see if the ''x_end_idler'' is parallel to the frame you can use a thick ruler or a square like on the first image. |
| + | [* 5] Verify that your Z lead screw is not touching the Z tops holes. If it is touching release the pressure from the X smooth rods tensioning screws like explained in the previous step. |
| + | [* 10] Note that Z lead screw does not need to be centered totally, it ca wobble a little. |
| + | [* 4] Double check that your belt is still well tensioned. In case it needs adjustment repeat the previous step. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added