Changes to this Step
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] X |
|---|---|
| + | [title] X axis length |
| [* 1] If you have difficulty to see if the ''x_end_idler'' is parallel to the frame you can use a thick ruler or a square like on the first image. | |
| [* 5] Verify that your Z lead screw is not touching the Z tops holes. If it is touching release the pressure from the X smooth rods tensioning screws like explained in the previous step. | |
| [* 10] Note that Z lead screw does not need to be centered totally, it ca wobble a little. |