Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Verify slicer version |
|---|---|
| + | [* 3] Start PrusaSlicer software and go to the top menu ''Help -> About ...'' |
| + | [* 5] Verify that the slicer version is equal or greater than 2.0.0. |
| + | [* 1] If version is equal or greater: go to the next step |
| + | [* 1] If your version is lower: download and install the version shown above from this page: [https://www.prusa3d.com/prusaslicer/|prusa3d.com/prusaslicer]. |
| + | [* 10] You can update to the most recent version, however, we may not have tested with that version. |
Image 1
No previous image
Added
Image 2
No previous image
Added