Changes to Step #11

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Verify slicer version
-[* 3] Start PrusaSlicer software and go to the top menu ''Help -> About ...''
+[* 3] Start PrusaSlicer and go to the top menu ''Help -> About ...''
[* 5] Verify that the slicer version is equal or greater than 2.0.0.
- [* 1] If version is equal or greater: go to the next step
+ [* 1] If the version is equal or greater: go to the next step
[* 1] If your version is lower: download and install the version shown above from this page: [https://www.prusa3d.com/prusaslicer/|prusa3d.com/prusaslicer].
[* 10] You can update to the most recent version, however, we may not have tested with that version.