Changes to Step #13

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Selftest and PID calibration
[* 1] Turn the printer off and and then on.
[* 5] Run the "Selftest" in calibration settings.
[* 9] If errors occur during selftest, please fix them before going further.
-[* 2] In Settings -> Temperature -> Fan speed set a value at 130 if you print lots of PETG and 255 if you print lots of PLA. For other materials select according to your most used filament.
+[* 2] In Settings -> Temperature -> Fan speed set the value at 130 if you print lots of PETG and 255 if you print lots of PLA. For other materials select a value suitable for your most used filament.
[* 7] Run PID calibration in calibration settings.
[* 7] Choose a temperature that matches your most used printing temperature.