Changes to Step #14
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z calibration preparation |
|---|---|
| + | [* 1] Heat up the nozzle by selecting Settings -> Temperature -> Nozzle: and insert PLA filament. |
| + | [* 1] Make sure you have the steel sheet on the printer. |
| + | [* 5] Run Calibration Z. You may repeat the procedure. |
| + | [* 10] Because the extrusion multiplier and filament diameter are not calibrated yet, it will only give a first approximation of the first layer height. |
Image 1
No previous image
Added