Changes to Step #14

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z calibration preparation
[* 1] Heat up the nozzle by selecting Settings -> Temperature -> Nozzle: and insert PLA filament.
[* 1] Make sure you have the steel sheet on the printer.
-[* 5] Run the Z Calibration. You may repeat the procedure.
+[* 5] Run the Z Calibration.
[* 10] Because the extrusion multiplier and filament diameter are not calibrated yet, it will only give a first approximation of the first layer height.