Changes to this Step
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [* 1] Verify that the printer is turned on and USB connected. | |
| [* 3] Start PrusaSlicer and navigate to the top menu ''Configuration -> Flash printer firmware'' | |
| [* 5] Select the Bear calibration firmware *.hex file using the ''Browse'' button. | |
| [* 8] Verify that the printer is detected in the "Serial port:" window. If not, check that the USB cable is firmly connected to both the printer and the computer. select "Rescan" | |
| - | [* 7] Click the button ''Flash!'' to flash the |
| + | [* 7] Click the button ''Flash!'' to flash the Prusa firmware. |
| [* 9] Never turn off the printer or disconnect the USB cable while flashing the firmware! | |
| [* 2] Wait until you get a ''Flashing succeeded!'' message. | |
| [* 10] In case of issues while flashing the firmware read the [https://help.prusa3d.com/article/gXdRubco3u-firmware-updating-flashing-problems?code=400&failed=1&reason=Multilingual+is+not+enabled+on+this+account|Prusa troubleshooting article]. |