Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] X End Idler |
|---|---|
| + | [* 2] Temporarily insert a 8mm smooth rod through both LM8UU linear bearings. |
| + | [* 4] Engage two M3x10 socket head screws in the hex nuts, but do not tighten them at this time. |
| + | [* 5] Alternatively tighten the two M3x10 clamp screws to secure the linear bearings. Slide the smooth rods back and forth while tightening. |
| + | [* 9] Don't over-tighten the clamp screws; they need to be just tight enough to keep the bearings from moving. |
| + | [* 1] Remove the 8mm smooth rod. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added