Changes to Step #15

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Assembling X Axis On Z Axis
-[* 10] These steps are using the Bear Upgrade frame 2.1 as example but can be applied to Original Prusa frame and previous Bear Upgrade frame version.
+[* 10] These steps are using the Bear Upgrade frame 2.1 as example but can be applied to Original Prusa frames and previous Bear Upgrade frame versions.
[* 4] Install the Z axis tops and tighten them.
[* 7] ***Bear Upgrade frame only:*** Make sure the ''z_tops'' are flush with the Z smooth rods on both sides
[* 2] ***Bear Upgrade frame only:*** Tighten the ''z_ends_caps'' back in place.