Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 1] Press an M3 hex nut into the ''extruder_body''. This nut will be hidden by the extruder heat sink. |
|---|---|
| + | [* 1] Locate the extruder motor so the wires face to the left. Rotate the shaft so that the flat is facing up. |
| + | [* 1] Mount the Bondtech pulley on the extruder motor shaft with the toothed portion on top with the grub screw contacting the flat portion of the shaft. |
| + | [* 1] Press the extruder motor to the ''extruder_body'' making sure the Bondtech grub screw is visible and that the wires exit the bottom of the extruder motor. |
| + | [* 1] Secure the extruder motor to the ''extruder_body'' using two M3x25 screws. |