Changes to Step #4

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder motor
[* 7] Locate the extruder motor so the wires face to the left. Rotate the shaft so that the flat is facing up.
[* 5] Mount the Bondtech pulley on the extruder motor shaft with the toothed portion on top with the set screw contacting the flat portion of the shaft.
-[* 2] The motor shaft should go out by approximately 1mm.
+[* 2] The motor shaft should protrude by approximately 1mm.
[* 1] Secure the set screw to avoid the gear moving. We will fine tune the position later.
[* 4] Verify the motor cables orientation.
[* 3] Secure the extruder motor to the ''extruder_body'' using two M3x25 screws.
[* 6] Verify the motor cables orientation