Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder motor |
|---|---|
| [* 7] Locate the extruder motor so the wires face to the left. Rotate the shaft so that the flat is facing up. | |
| [* 5] Mount the Bondtech pulley on the extruder motor shaft with the toothed portion on top with the set screw contacting the flat portion of the shaft. | |
| [* 2] The motor shaft should go out by approximately 1mm. | |
| [* 1] Secure the set screw to avoid the gear moving. We will fine tune the position later. | |
| [* 4] Verify the motor cables orientation. | |
| [* 3] Secure the extruder motor to the ''extruder_body'' using two M3x25 screws. | |
| [* 6] Verify the motor cables orientation |