Changes to Step #10
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder idler preparation |
|---|---|
| + | [* 3] Place the idler gear into the ''extruder_idler''. Note the orientation of the teeth. |
| + | [* 9] Make sure that both idler are still present in the idler gear. |
| + | [* 5] Insert the shaft from the direction shown as on the figure. |
| + | [* 1] Insert a square nut in the pocket lateral pocket. |
| + | [* 9] Double check the orientation of the gears. |
| + | [* 9] Double check that no needle bearing fall off during these steps |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added