Changes to Step #10

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler preparation
[* 3] Place the idler gear into the ''extruder_idler''. Note the orientation of the teeth.
[* 9] Make sure that both needle bearings are still present in the idler gear.
-[* 5] Insert the shaft from the direction shown as on the figure.
-[* 1] Insert a square nut in the pocket lateral pocket.
+[* 5] Insert the shaft from the direction as shown in the figure.
+[* 1] Insert a square nut in the lateral pocket.
[* 9] Double check the orientation of the gears.
-[* 9] Double check that no needle bearing fall off during these steps
+[* 9] Double check that no needle bearings fell out during these steps