Changes to Step #10

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler preparation
[* 3] Place the idler gear into the ''extruder_idler''. Note the orientation of the teeth.
-[* 9] Make sure that both idler are still present in the idler gear.
+[* 9] Make sure that both needle bearings are still present in the idler gear.
[* 5] Insert the shaft from the direction shown as on the figure.
[* 1] Insert a square nut in the pocket lateral pocket.
[* 9] Double check the orientation of the gears.
[* 9] Double check that no needle bearing fall off during these steps