Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder idler assembly |
|---|---|
| + | [* 5] Slide a M3 washer on a M3x40 screw. |
| + | [* 3] Insert the screw on top left hole of the ''x_carriage'' until it just get out inside the ''extruder_body''. |
| + | [* 4] Add a M3 nylon washer on the end of the screw. |
| + | [* 2] Add the ''extruder_idler'' in the opening. and push the screw. |
| + | [* 7] Leave a space to insert the second M3 nylon washer. |
| + | [* 8] Insert the second M3 nylon washer and finish to push the screw to secure it. |
| + | [* 8] Slightly tighten the screw, the ''extruder_idler'' must rotate freely. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added