Changes to Step #11

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler assembly
[* 5] Slide a M3 washer on a M3x40 screw.
-[* 3] Insert the screw on top left hole of the ''x_carriage'' until it just get out inside the ''extruder_body''.
+[* 3] Insert the screw in the top left hole of the ''x_carriage'' until it is just protruding from the other side of the ''extruder_body''.
[* 4] Add a M3 nylon washer on the end of the screw.
[* 2] Add the ''extruder_idler'' in the opening. and push the screw.
[* 7] Leave a space to insert the second M3 nylon washer.
-[* 8] Insert the second M3 nylon washer and finish to push the screw to secure it.
-[* 8] Slightly tighten the screw, the ''extruder_idler'' must rotate freely.
+[* 8] Insert the second M3 nylon washer and push the screw further to secure it.
+[* 8] Slightly tighten the screw, ensuring that the ''extruder_idler'' can still rotate freely.