Changes to Step #12
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Hotend assembly |
|---|---|
| + | [* 10] Hotend wires are not visible on these images. Use the heatblock to orientate the hotend correctly. |
| + | [* 3] Push down the PTFE while raising up the collet. |
| + | [* 6] Insert the ''hotend_collet_clip''. This locks the PFTE tube in place. |
| + | [* 5] Insert the hot end into the ''extruder_body'' so that the heater and thermistor wires are properly oriented. |
| + | [* 2] Note the position of the heater and thermistor wires. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added