Changes to Step #12

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Hotend assembly
-[* 10] Hotend wires are not visible on these images. Use the heatblock to orientate the hotend correctly.
-[* 3] Push down the PTFE while raising up the collet.
+[* 10] Hotend wires are not visible in these images. Use the heatblock to orientate the hotend correctly.
+[* 3] Push down the PTFE tube while raising up the collet.
[* 6] Insert the ''hotend_collet_clip''. This locks the PFTE tube in place.
[* 5] Insert the hot end into the ''extruder_body'' so that the heater and thermistor wires are properly oriented.
[* 2] Note the position of the heater and thermistor wires.