Changes to Step #14
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Hotend fan assembly |
|---|---|
| + | [* 2] Carefully route the motor wires as shown in the figure. |
| + | [* 4] Make sure the wires sit correctly in the channel. |
| + | [* 7] This surface will be touching the ''extruder_body''. Wires are going out from this side. |
| + | [* 5] Carefully route the hotend fan wires in the ''x_carriage''. |
| + | [* 3] Attach the hotend fan with four M3x14 rounded head screws. |
| + | [* 9] Check that no wire are pinched. |
| + | [* 9] Check hotend fan orientation. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added