Changes to Step #14

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Hotend fan assembly
[* 2] Carefully route the motor wires as shown in the figure.
[* 4] Make sure the wires sit correctly in the channel.
[* 7] This surface will be touching the ''extruder_body''. Wires are going out from this side.
[* 5] Carefully route the hotend fan wires in the ''x_carriage''.
[* 3] Attach the hotend fan with four M3x14 rounded head screws.
-[* 9] Check that no wire are pinched.
+[* 9] Check that no wires are pinched.
[* 9] Check hotend fan orientation.