Changes to Step #15
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Bondtech gear alignment |
|---|---|
| + | [* 7] Open the ''extruder_idler'' |
| + | [* 5] Insert a piece of 1.75 mm filament through the ''extruder_body'' into the PFTE tube. |
| + | [* 4] Using the Bondtech set screw, carefully center the filament on the drive teeth. |
| + | [* 4] Tighten the set screw. Don't tighten too much as you will damage the thread. |
| + | [* 1] Remove the filament. |
| + | [* 8] It is the good moment to put a dab of lithium based grease on the gears. Make sure to not put grease on the drive teeth. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added