Changes to Step #15

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Bondtech gear alignment
[* 7] Open the ''extruder_idler''
[* 5] Insert a piece of 1.75 mm filament through the ''extruder_body'' into the PFTE tube.
[* 4] Using the Bondtech set screw, carefully center the filament on the drive teeth.
[* 4] Tighten the set screw. Don't tighten too much as you will damage the thread.
[* 1] Remove the filament.
-[* 8] It is the good moment to put a dab of lithium based grease on the gears. Make sure to not put grease on the drive teeth.
+[* 8] This is a good moment to put a dab of lithium based grease on the gears. Make sure to only put grease on the gears, not the drive teeth!