Changes to Step #16
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder idler tensioner screw |
|---|---|
| + | [* 1] Make sure you have totally removed the filament from the ''extruder_body''. |
| + | [* 1] Slide an extruder spring on a M3x40 screw. |
| + | [* 1] Close the ''extruder_idler'' door. |
| + | [* 3] Slide the screw with the extruder spring in the ''extruder_body''. |
| + | [* 3] Tighten the screw until the head is at the same level than the surface of the body. |
| + | [* 10] If you have trouble to close the ''extruder_idler'', try to rotate the Bondtech idler gear with a finger. |
Image 1
No previous image
Added
Image 2
No previous image
Added