Changes to Step #16

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler tensioner screw
[* 1] Make sure you have totally removed the filament from the ''extruder_body''.
[* 1] Slide an extruder spring on a M3x40 screw.
[* 1] Close the ''extruder_idler'' door.
[* 3] Slide the screw with the extruder spring in the ''extruder_body''.
[* 3] Tighten the screw in the ''extruder_idler'' until the head is flush with the surface of the body.
-[* 10] If you have trouble to close the ''extruder_idler'', try to rotate the Bondtech idler gear with a finger.
+[* 10] If you have trouble closing the ''extruder_idler'', try rotating the Bondtech idler gear with your finger.