Changes to Step #7

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Filament sensor assembly
-[* 9] In order to avoid electrostatic discharge to the filament sensor, touch something metallic that is linked to the ground. Like pipework or faucet.
-[* 10] Verify that the laser sensor is clean. If not use a cotton bud (q-tip) with a dab of Isopropyl alcohol.
+[* 9] In order to avoid electrostatic discharge to the filament sensor, touch something metallic that is linked to the ground, for example pipework or a faucet.
+[* 10] Verify that the laser sensor is clean. If not, use a cotton bud (q-tip) with a dab of Isopropyl alcohol.
[* 3] Insert the filament sensor into the ''extruder_body''. Avoid touching any of the components on the PCB.
[* 6] Using an M3x10 screw, secure the filament sensor.
[* 9] Don't over-tighten the filament sensor to avoid damaging the PCB.