Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Filament sensor assembly | |
| [* 9] In order to avoid electrostatic discharge to the filament sensor, touch something metallic that is linked to the ground. Like pipework or faucet. | |
| [* 10] Verify that the laser sensor is clean. If not use a cotton bud (q-tip) with a dab of Isopropyl alcohol. | |
| [* 3] Insert the filament sensor into the ''extruder_body''. Avoid touching any of the components on the PCB. | |
| [* 6] Using an M3x10 screw, secure the filament sensor. | |
| + | [* 9] Don't over-tighten the filament sensor to avoid damaging the PCB. |