Changes to Step #18
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Pinda probe assembly |
|---|---|
| + | [* 4] Place a square nut in the ''extruder_body'' for the ''pinda_mount''. |
| + | [* 8] Slide an M3x10 screw in the ''pinda_mount'' and engage the square nut, but do not tighten. |
| + | [* 5] Insert the Pinda in the mount so that the sensor end is 12mm below the bottom of the ''pinda_mount''. Tighten the screw just enough to keep the Pinda from falling out. The optimum Pinda position will be adjusted later. |
| + | [* 2] Route the Pinda wires |
| + | [* 7] Route the print fan wires |
| + | [* 3] Secure the Pinda cable with a zip tie. Be sure to leave some slack since the Pinda position will need to be adjusted later. |
| + | [* 6] This is an example of how the Pinda cable should be wired. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added