Changes to Step #18

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Pinda probe assembly
[* 4] Place a square nut in the ''extruder_body'' for the ''pinda_mount''.
[* 8] Slide an M3x10 screw in the ''pinda_mount'' and engage the square nut, but do not tighten.
[* 5] Insert the Pinda in the mount so that the sensor end is 12mm below the bottom of the ''pinda_mount''. Tighten the screw just enough to keep the Pinda from falling out. The optimum Pinda position will be adjusted later.
[* 2] Route the Pinda wires
[* 7] Route the print fan wires
-[* 3] Secure the Pinda cable with a zip tie. Be sure to leave some slack since the Pinda position will need to be adjusted later.
-[* 6] This is an example of how the Pinda cable should be wired.
+[* 3] Secure the cables with a zip tie. Be sure to leave some slack since the Pinda position will need to be adjusted later.
+[* 6] This is an example of how the Pinda and print fan cables should be wired.