Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Back and front extrusions |
| [* 6] Make sure the plates are flushed with the extrusion and tighten strongly the M5 screws (no more than 4.5Nm if you have a tool to measure). | |
| [* 2] To help aligning the plate while tightening you can use a second plates and a flat surface. | |
| [* 5] Then press the plates against extrusions and the flat surface with one hand and tighten the M5 screws. | |
| [* 1] Repeat this with the plate on the other side of the extrusion. |