Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Back and front extrusions
[* 9] Take your time with this step, the plate needs to be well flushed as it could affect the rest of the assembly.
[* 6] Make sure the plates are flushed with the extrusion and tighten strongly the M5 screws.
[* 2] To help aligning the plate while tightening you can use a second plates and a flat surface.
- [* 5] Then press the plates against extrusions and the flat surface with one hand and tighten the M5 screws.
+ [* 5] Then press the plates against the extrusion and the flat surface with one hand and tighten the M5 screws.
[* 1] Repeat this with the plate on the other side of the extrusion.