Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Back and front extrusions
[* 9] Take your time with this step.
[* 2] Take an extra joining plate and place it as shown on the 1st image. We will use it to ease the alignment.
[* 5] Press the plates as shown on the second image (small green arrows) and tighten strongly the M5 screws.
[* 6] Check that your plate is correctly flushed with the extrusion.
- [* 9] This is important as it could affect the rest of the assembly.
+ [* 9] This is important as other steps will depends on this assembly.