Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Back and front extrusions | |
| [* 9] Take your time with this step. | |
| - | [* 2] Make sure you are on a flat surface |
| + | [* 2] Make sure you are on a flat and plane surface. |
| [* 7] Take an extra joining plate and place it as shown on the 1st image. We will use it to ease the alignment. | |
| [* 5] Press the plates as shown on the second image (small green arrows) and tighten strongly the M5 screws. | |
| [* 6] Check that your plate is correctly flushed with the extrusion. | |
| [* 9] This is important as other steps will depends on this assembly. |