Changes to Step #4

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Back and front extrusions
[* 9] Take your time with this step.
-[* 2] Make sure you are on a flat and plane surface.
-[* 7] Take an extra joining plate and place it as shown on the 1st image. We will use it to ease the alignment.
-[* 5] Press the plates as shown on the 2nd image (small green arrows) and tighten strongly the M5 screws.
-[* 6] Check that your plate is correctly flushed with the extrusion.
- [* 9] This is important as other steps will depends on this assembly.
+[* 2] Make sure that you are workng on a flat and level surface.
+[* 7] Take a joining plate and hold it against the extrusion, as shown in the 1st image. We will use it to aid in the alignment of the first joining plate
+[* 5] Hold the plates as shown in the 2nd image, applying pressure as shown (small green arrows) and fully tighten both M5 screws.
+[* 6] Check that your plate is flush with the face and end of the extrusion.
+ [* 9] This is an important step as other steps will rely on the accuracy of this assembly.