Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Back and front extrusions | |
| [* 9] Take your time with this step. | |
| [* 2] Make sure that you are workng on a flat and level surface. | |
| [* 7] Take a joining plate and hold it against the extrusion, as shown in the 1st image. We will use it to aid in the alignment of the first joining plate | |
| - | [* 5] Hold the plates as shown in the 2nd image, applying pressure as shown (small green arrows), and tighten both M5 screws. |
| + | [* 5] Hold the plates as shown in the 2nd image, applying pressure as shown (small green arrows), and tighten both M5 screws fully. |
| [* 6] Check that your plate is flush with the face and end of the extrusion. | |
| [* 9] This is an important step as other steps will rely on the accuracy of this assembly. |