Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Back and front extrusions
[* 9] Take your time with this step.
-[* 2] Make sure that you are workng on a flat and level surface.
+[* 2] Make sure that you are workng on a flat and hard surface.
[* 7] Take a joining plate and hold it against the extrusion, as shown in the 1st image. We will use it to aid in the alignment of the first joining plate
-[* 5] Hold the plates as shown in the 2nd image, applying pressure as shown (small green arrows), and tighten both M5 screws fully.
+[* 5] Hold the plates as shown in the 2nd image, applying pressure as shown (small green arrows), and tighten both M5x10 screws fully.
[* 6] Check that your plate is flush with the face and end of the extrusion.
[* 9] This is an important step as other steps will rely on the accuracy of this assembly.