Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Left and right Y axis extrusions |
|---|---|
| + | [* 5] Take the two middle length extrusions on the pile of not used yet. They are 331mm long. |
| + | [* 3] Add 4 t-nuts as seen on the pictures. |
| + | [* 6] Using 4 M5x10 screws, assemble one of the extrusion+plates of the previous steps with the two 331mm long. Do not tighten them fully yet. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added