Changes to Step #7

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Reference corner assembly
-[* 5] Take one the two middle length extrusions on the pile of unused. It is 331mm long.
+[* 5] Take one of the 331mm* extrusions. (*The middle length of the five remaining extrusions)
[* 1] Prepare the following parts:
- [* 4] 1x previous extrusion and plate assembly
- [* 6] 2x t-nuts. Slide them in the 331mm extrusion as shown on the picture.
+ [* 4] 1x previously completed extrusion and plate assembly
+ [* 6] 2x t-nuts. Slide them into the 331mm extrusion as shown in the picture.
[* 2] 2x M5x10 screws
-[* 7] Assemble the corner with the M5 screws. Do not tighten fully yet!
+[* 7] Assemble the corner, as shown, using the 2x M5 screws. Do not fully tighten these two screws!