Changes to Step #11

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 5] Take one the last middle length extrusions on the pile of not used yet. It is 331mm long.
[* 1] Prepare the following parts:
- [* 6] Two M5x10 screws.
- [* 2] Two t-nuts. Slide them in the 331mm extrusion as shown on the picture.
+ [* 6] 2x M5x10 screws.
+ [* 2] 2x t-nuts. Slide them in the 331mm extrusion as shown on the picture.
[* 7] Assemble the 331mm extrusion with the M5 screws. Do not tighten it fully yet, it need to be able to move a little bit.