Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] XY base squaring |
| [* 5] Take one the last middle length extrusions on the pile of not used yet. It is 331mm long. | |
| [* 1] Prepare the following parts: | |
| [* 6] 2x M5x10 screws. | |
| [* 2] 2x t-nuts. Slide them in the 331mm extrusion as shown on the picture. | |
| [* 7] Assemble the 331mm extrusion with the M5 screws. Do not tighten it fully yet, it need to be able to move a little bit. |