Changes to Step #11

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] XY base assembly
-[* 5] Take one the last middle length extrusions on the pile of not used yet. It is 331mm long.
+[* 5] Take the last middle length extrusions on the pile of unused. It is 331mm long.
[* 1] Prepare the following parts:
[* 6] 2x M5x10 screws.
[* 2] 2x t-nuts. Slide them in the 331mm extrusion as shown on the picture.
-[* 7] Assemble the 331mm extrusion with the M5 screws. Do not tighten it fully yet, it need to be able to move a little bit.
+[* 7] Assemble the 331mm extrusion with the M5 screws. Do not tighten it fully yet!