Changes to Step #11

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] XY base assembly
-[* 5] Take the last middle length extrusions on the pile of unused. It is 331mm long.
+[* 5] Take the remaining 331mm* extrusion. (*The middle length of the four remaining extrusions)
[* 1] Prepare the following parts:
[* 6] 2x M5x10 screws.
- [* 2] 2x t-nuts. Slide them in the 331mm extrusion as shown on the picture.
-[* 7] Assemble the 331mm extrusion with the M5 screws. Do not tighten it fully yet!
+ [* 2] 2x t-nuts. Slide them into the 331mm extrusion as shown in the picture.
+[* 7] Attach the 331mm extrusion, to the assembly, with the M5 screws. Do not fully tighten them yet!